0 Products in basket
-Unipro 3005 UniGo
-Unipro 5005 UniGo
-Unipro 6005 UniGo
SENSORS - UNIGO
Unipro 6005 UniGo
Usually ships within:
Lap time, position, RPM, 2 x temperature, speed, gear, ambient temperature, voltage. Logged at up to 60 Hz
RPM, 2 x temperature*, speed*, trigger, external power and expansion
Magnet, infrared, active loop, GPS
Magnets, wheel sensor
256 x 160 pixels, 16 gray scales
5 high-brightness, fully programmable
USB high-speed via optional USB cable or optional Unipro Flash key
131.5 x 94.0 x 18.0 mm (5.18" x 3.70" x 0.71")
* Shared connector: Optional cable splitter needed
UniGo 6005 is both a Laptimer and a Data Logger. It means that all data are stored in the Laptimer at up to 60 times per second. It makes it possible to transfer the results to a PC or MAC for further analyzing. The included analyze program will give you the complete overview together with the possibility to compare results between drivers, training sessions and heats.
The kit contains the Laptimer with free choice of receiver (magnet, loop or IR), RPM wire, power cable and a battery holder for six AA batteries. It gives you the possibility to measure lap times and engine revolutions.
Show with VAT
The UniBox expands UniGo 5005, 6005 or 8005 and allows a large number of basic and advanced sensors to be connected to the system. If more sensors are needed - another UniBox can be added.
To prepare the UniBox for the future, it has been made as flexible as possible. All known sensors can be connected, and with future software updates, it should also be ready for future sensors or even your own custom sensors.
Price: 549,00 EUR
USB Flash key for UniGo
The USB Flash key is used for data transfer from one or several UniGo Laptimer(s) to a computer. The transfer will included all the data in the Laptimer, that is lap times, setup and all logged data. Flash key is connected to a computer using a small adaptor cable. Very suitable for teams with more than one UniGo.
Price: 120,00 EUR
USB cable for UniGo
The USB cable is used for data transfer from an UniGo Laptimer to a computer. The transfer will included all the data in the Laptimer, that is lap times, setup and all logged data.
Price: 37,00 EUR
Sensor splitter, Black - UniGo
This splitter can be used for all inputs except temperature. It can for instance be used for splitting the RECV input on UniGo into a receiver and speed input.
Price: 42,00 EUR
Temperature splitter, Gray - UniGo
This splitter is used for expanding a single temperature input into two inputs. UniGo/UniBox will auto detect the attached sensors.
Price: 42,00 EUR
DC/DC converter for kart battery - UniGo
The sensor fits:
UniGo 3005, 5005, 6005, 8005
Price: 60,00 EUR
Battery, LiPo, 11.1V 2200 mAh - UniGo
Price: 32,00 EUR
Mounting set for GPS antenna - UniGo
The mounting set fits:
UniGo 6005, 8005
Price: 26,00 EUR